Phone: (434) 946-9125
Email: support@gomeasure3d.com

Support Center

How to Align Scans in Artec Studio

Last Updated: Aug 15, 2017 12:58PM EST
Many times an object may need to be scanned multiple times in order to get all sides.  These scans need to be aligned so they can be merged together at the correct orientation. This is a guide to teach a user how to align scans when using Artec Studio.  For this demonstration a wooden elephant was scanned upright and upside down.

1. The user will need multiple scans they wish to align loaded.  Then select the align tab



2. Select a point that is clear on both scans.  Then click on that point on each scan to create a pair.  The point of the tusk was used on this model.  On the left in the middle of the page, the individual scans are highlighted.  Clicked on one or the other to toggle the view.  This can make it easier to click on the area you want.  



3. Repeat for 3 different points on both scans



4. Click Align Markers to roughly align the scans.  Then click Auto-Alignment to run an additional algorithm that tightly matches the pattern and geometry of the two scans.



Click Apply in the bottom left and your scans are aligned! From here the model can be processed in the Tools tab or finished in the Auto-Pilot tab.
Support@gomeasure3d.com
http://assets0.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete