Calibration | Subjects | GoMeasure3D Support

HDI Advance Scanner Calibration Tutorial

Aug 29, 2018

Calibrating a HDI scanner can be a daunting task. With a few tips and tricks it gets a lot easier with much better results. A clean calibration can result in better quality of scan data and it can make the system much easier to use. Here is a section of the HDI Advance User Guide […]
Rotary Table Calibration Setup

Aug 29, 2018

A rotary table can greatly speed up the 3D scanning process. In order for FlexScan3D to recognize the position of the table it needs to be calibrated before scanning. This video shows that process:
Calibration Board Sizes for Various Fields of View (FOV)

Aug 29, 2018

Many people wonder what calibration board size they should use for a given scanning setup. Make sure your calibration board is 1/3 of the camera’s live view. If you are using the lenses that came with the system, the required calibration board sizes are as follows: Field of View (FOV)Calibration Board Size200 mm7 mm400 mm15 […]
Changing the Projector and Camera Lens After Calibration

Aug 16, 2018

We do not recommend changing the focus after your system has been calibrated. You may change the projector focus slightly after calibration but only to where the stand off is. Do not adjust the focus every time you make a scan.